Tacking; To Sew; To Sew A Shorter Tack; To Sew A Same-Sized Tack - Janome Hello Kitty 18750 Manual De Instrucciones

w e
q
w
e
t
q w e
q
r
r
q
w
e

Tacking

Machine setting
q Stitch pattern:
w Needle thread tension:
e Presser foot:
Tacking is used to reinforce pockets, crotches and belt car-
riers where extra strength is needed.

• To sew

Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 5/8˝ (1.5 cm)
long.
q 5/8˝ (1.5 cm)

• To sew a shorter tack

* Set the speed control slider at low speed setting.
To sew a tack shorter than 5/8˝ (1.5 cm), first stop the
machine at the end of required length w, then press the
reverse stitch button e.
The tack length r has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w Required length
e Reverse stitch button
r Tack length
t Starting point

• To sew a same-sized tack

Simply start the machine to sew another tack at the same
size.

Eyelet

Machine setting
q Stitch pattern:
w Needle thread tension: 1 to 4
e Presser foot:
The eyelet is used for belt holes etc.
• To sew
Attach the satin stitch foot F.
Start the machine. The machine will stop
automatically when completed.
Open the eyelet with an awl, eyelet punch or pointed
scissors.

• To adjust the shape of an eyelet

Correct the shape of the eyelet as follows:
Press the cursor buttons to move the cursor under
the value "L3" (default setting) q.
If the eylet gap opens w, press the button to make the
darn even. (L1 – L2)
If the eylet overlaps e, press button to make the darn
even. (L4 – L5)
NOTE:
The shape can be adjusted within L1 to L5 (default
setting is L3).
74
09
3 to 6
Satin stitch foot: F
49
Satin stitch foot: F