Preselection For Permanent Unit Deactivation - Monosem S6200-24 Manual De Instrucciones

4.2.2 Preselection for Permanent Unit Deactivation

Pressing the key takes you from the "Results 1" screen to the permanent unit deactivation screen.
The and
indicates the unit that is selected.
The key is to be used to change the status of the unit.
A unit is preselected for permanent deactivation if it is shown as follows .
All units which are shown with this symbol
The preselection for permanent deactivation can be reversed again for all units by using the key
!
Caution: If the status of one of the units is changed, all preselected units are deactivated.
The permanent deactivation is reversed again by pressing the
Depending on the configuration of the "Headland -perm.TB" parameter in the machine data, the permanent deactivation is also
reversed at the end of the field.
The preselection persists in both cases and can be activated again at any time by using the
keys can be used to select the unit, the status of which should be changed. An arrow below the units
remain unaffected by the permanent deactivation.
Figure 4-6 Preselection for permanent unit deactivation
key in the work screen.
29
.
key in the work screen.