Corghi Artiglio 500 Manual De Uso página 70

• Remove the gripper.
• Now demount the underside of the tyre, taking care not to damage the sensor.
• Lubricate both tyre beads.
• Place the sensor at 2 or 3 o'clock (valve at 8 o'clock).
• Set the tyre at an angle of about 45 degrees.
• Turn the tyre so that it is touching the tyre mounting head and is starting to be mounted
on the rim.
• Turn the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock (valve at 10 o'clock).
• Lower the bead breaker to allow a bead presser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of
the tyre inside the open centre during rotation.
• Rotate the tyre and make the necessary adjustments until the upper bead has been
mounted.
• It may be useful to assist the operation with a second RunFlat gripper and/or the bead
presser accessory, if available.
• Using the bead breaker disc, remove the RunFlat grippers used.
• Connect the inflation line to the valve for bead insertion.
70
MOUNTING
Operator's manual Artiglio 500