Job Number (Bits 0 ÷ 2); Gas Test - Cebora 217-01 Manual De Istrucciones

CEBORA S.p.A
5.6 Job Number (bits 0 ÷ 2).
Terminal
9
11
13
-
The "Job Number" function is available when "Job Mode" has been selected with the operating mode.
When a "Job Number" is selected, a working settings value is recalling from Power Source memory, no
welding parameter can be changed neither from Power Source nor from Robot.
With the "Job Number" function, stored welding parameters can be retrieved with reference to the
number of the respective Job.
If the "Job Number" selected is empty, "PrG" plus Job number requested blinking message is displayed
on the Control Panel.
NOTE: Job Number "0" allows the user to select a Job on the Control Panel.
Digital input
signals for
Tig/Job
selection
Digital input
signals
Power Source Ready
Digital output
signals
5.7

Gas Test.

Gas Test:
Reference potential:
The "Gas Test" signal actuates the "Gas Test" function.
The "Gas Test" signal actuates the gas solenoid valve, and so corresponds to the "Gas Test" button on the
Control Panel or on the Wire Feeder.
3.300.129-C
Connector
J10, pin 9
J11, pin 1
J11, pin 3
J1, pin 2
Tig functions 1
Job Number
bit (0 - 2) 0
1
Robot Ready
0
1
Arc-on
0
1
0
1
Process Active
0
1
Current Flow
0
1
Main Current
0
fig. 5
+24 Vdc = J11, pin 5.
Gnd = J1, pin 2.
Signal Program Bit
+24V
+24V
+24 V
Gnd Reference potential
31
0
1
2
GB
26/01/2011