Receiving Inspection; Storage; Disposal And Recycling - WEG Motor Scan Manual General De Instalación Y Operación

www.weg.net
NOTE!
Read the whole manual before installing or operating the WEG Motor Scan.
DANGER!
Only qualified people familiar with the WEG Motor Scan should plan or execute the installation,
operation and maintenance of this device.
Such personnel must follow the safety instructions described in this guide and/or defined by local regulations.
For safety reasons, keep a safe distance from the sensor and from the motor during its operation (no less than
20 cm), allowing only authorized personnel to get close.
Failure to comply with the safety instructions may lead to death and/or damages to the device.
There are risks of explosion or fire when they are exposed to flame, subjected to pressure or come into contact
with energy-carrying materials (metals or liquids), in addition to contaminating the environment due to the
materials used in their composition.

3.1. RECEIVING INSPECTION

At the receipt of the WEG Motor Scan, check that the packaging contains the following items: 1 sensor, 1 fixing
screw (M4x20mm) and 1 fixing bushing. Check the sensor immediately after unpacking to identify possible
damages occurred due to improper transportation.
Figure 3.1 - Sensor
DANGER!
All damages must be reported in writing to the transportation company, to the insurance company and
to WEG. Failure to comply with such procedures will void the product warranty.

3.2. STORAGE

NOTE!
It is recommended to store the WEG Motor Scan at a maximum temperature of 30 °C and not exposed
to direct sunlight.
NOTE!
The WEG Motor Scan supplied inactive from the factory.
NOTE!
The WEG Motor Scan is shipped with a Lithium-thionyl Chloride Battery (Li-SOCl

3.3. DISPOSAL AND RECYCLING

WEG is committed to the environment and supplies products that contribute to reducing the environmental
impacts along their life cycle. The user's participation in the waste sorting and recycling of the battery and
electro-electronic devices is also important to minimize their potential impact on the environment and human
health.
The proper disposal of the sensor, observing the applicable laws, is very important for your safety and also of
the environment, in addition to helping save resources.
36 Manual of Electric Motors
Figure 3.2 - Fixing screw M4x20mm Figure 3.3 - Fixing bushing
).
2