Procedure To Install The Sensor On The Motor; Sensor Firmware Updating - WEG Motor Scan Manual General De Instalación Y Operación

7.6. PROCEDURE TO INSTALL THE SENSOR ON THE MOTOR

For the correct mounting of the sensor on the motor, follow the steps below:
1. With the motor turned off and following all the safety instructions in this manual, locate the motor fin where
the sensor must be fixed. According to the positioning guidelines indicated in item 7.2, make the marking to
drill.
2. Drill a hole using a 5.9 mm (15/64") drill bit to fasten the bushing.
3. Using a hammer, insert the knurled bushing into the hole until the flange touches the motor fin.
(Note: If the sleeve is inserted without the aid of hammer means that the hole was slightly larger diameter, in
which case the sensor fixing the engine will be compromised Therefore, it is necessary to make a new hole
for the correct fixing of the bushing).
4. Using a 3 mm allen wrench, screw the sensor into the knurled bushing and check its tightness. Maximum
tightening torque of 2.8 Nm.

7.7. SENSOR FIRMWARE UPDATING

To update the sensor firmware, follow the procedure below:
1. Pair the sensor by selecting it on the mobile app home screen. You must be near the sensor and have an
internet connection.
2. Wait for the data stored in memory to be collected.
3. Click on "More."
4. Click on "Update Sensor."
5. Wait for the update to finish. You will be prompted to enter the motor data again.
6. Ready! The sensor is upgraded.
Figure 7.9 – Detail of insertion of the knurled bushing
Figure 7.10 – Sensor tightening detail on knurled bushing
www.weg.net
Manual of Electric Motors 59