Sensor Configuration - WEG Motor Scan Manual General De Instalación Y Operación

www.weg.net
2. Press "NEW DEVICE" and then "SELECT". On the
device selection screen, press ""Enable."
3. Place the sensor in the horizontal
position as shown in the app,
and press "START". Wait for 15
seconds, turn over the sensor,
leaving it with the WEG logo facing
downwards, as shown in the app.
Press "CONTINUE" and wait for 15
seconds again.
4. After 15 seconds, the app will direct you to the manual or NFC pairing screen, if your smartphone model
has such functionality.
To perform manual pairing, position the sensor to be configured as close as possible to the smartphone,
ensuring that no other sensors are nearby. Select the first sensor from the list.
To perform the pairing using the NFC, press "SCAN SENSOR". Bring the back of the sensor close to the
smartphone NFC region, as indicated in the app. After the NFC reading, the sensor will be paired with the
smartphone and activation will be automatically completed.

7.3. SENSOR CONFIGURATION

After installation and registration of the app and sensor activation is necessary to configure the sensor. The
steps to configure the sensor can be viewed directly in the app or as indicated in the steps below:
1. Include new sensor:
Click on the "NEW SENSOR" button and pair the
sensor using NFC or with the camera (it depends
on the model of the mobile device).
52 Manual of Electric Motors
or