DAB E.sybox Instrucciones Para La Instalación Y El Mantenimiento página 92

GB
ENGLISH
The addresses set manually can have values form 1 to 4. The configura-
tion of the addresses must be the same for all the devices that make up
the group: either all automatic or all manual. Setting the same addresses
is not allowed.
Both in the case of assigning mixed addresses (some manual and some
automatic) and in the case of duplicate addresses, an error signal is
given. The error signal is given by displaying a flashing E in the place of
the machine address.
If the chosen assignment is automatic, whenever the system is switched
on addresses are assigned that may be different from the previous time,
but this does not affect correct operation.
7.5.4 - MS: Measuring system
Set the measuring system, choosing between metric and imperial units.
The quantities displayed are shown in Table 13.
NOTE: The flow in English-speaking units (gal/min) is indicated adopt-
ing a conversion factor of 1 gal = 4.0 litres, corresponding to the metric
gallon.
Units of measurement displayed
Quantity Metric units
Pressure
Temperature
Flow rate
Table 13: Measuring system
7.5.5 - AS: Association of devices
Allows connection/disconnection with the following devices
e.sy Other e.sybox pump for operation in a pump set
•
92
Imperial units
bar
psi
°C °F
l / min gal / min
composed of max 4 elements
•
COM PWM Com communication control unit
•
TERM PWM Term remote control terminal
•
e.sylink e.sylink input output control unit
•
DEV Any other compatible devices
•
The icons of the various connected devices are displayed on page AS
with below an identifying acronym and the respective reception power.
An icon lit with a fixed light means that the device is connected and work-
ing correctly; a stroked through icon means the device is configured as
part of the network but is not found.
All the devices present over the air are not displayed on this
page but only the devices that have been associated with our
network.
Seeing only the devices in your own network allows the opera-
tion of several similar networks existing within the radius of
action of the wireless without creating ambiguity; in this way the
user does not see the elements that do not belong to his pump-
ing system.
From this menu page it is possible to associate and disassociate an ele-
ment from your personal wireless network.
When the machine starts the AS menu item does not show any connec-
tion because no device is associated. In these conditions the message
"No Dev" is shown and the COMM led is off. Only an action by the
operator can allow devices to be added or removed with the operations of
association and disassociation.
Association of devices
Pressing '+' for 5 sec puts the machine into the mode where it searches
for wireless association, communicating this status by the blinking of the
COMM leds at regular intervals. As soon as two machines in a working
communication range are put into this status, if possible, they are associ-
ated with each other. If the association is not possible for one or both
machines, the procedure ends and a pop-up appears on each machine
saying "association not possible". An association may not be possible
because the device you are trying to associate is already present in the