Transporting; Lawn Maintenance - Sabo 92-13 HF Manual Del Operador

HOW TO USE THE MACHINE
WARNING!
prevent the risk of tipping over. Reduce the forward speed before going on a
slope, particularly downhill.
DANGER!
cause you to lose control of the vehicle, especially on slippery ground.
Go down slopes with your foot off the drive pedal (
of the hydrostatic drive when the transmission is not engaged.

5.6 TRANSPORTING

WARNING!
with suitable resistance, width and length. Load the machine with the engine
switched off, without a driver and pushed by an adequate number of people.
During transport, close the fuel stopcock (if fitted), lower the cutting deck,
engage the parking brake and fasten the machine securely with ropes or
chains to the hauling device.

5.7 LAWN MAINTENANCE

1. To keep a lawn green, soft and attractive, it should be cut regularly without damag-
ing the grass. A lawn can be composed of different types of grass. If the lawn is cut
frequently, grass and roots grow more vigorously, forming a solid grassy bed. If the
lawn is cut is less frequently, higher grass and weeds start growing (plus daisies
and clovers, etc.).
2. It is always better to cut the grass when dry.
3. The blades must be in good condition and well sharpened so that the grass is cut
straight without a ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass and to
get the necessary thrust to push the cuttings through the collector channel.
5. The frequency of mowing should be in relation to the rate of growth of the grass.
The grass should not be left to grow too much between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher to prevent the
ground from drying out.
Start moving forwards very carefully on sloping ground to
Never use reverse to reduce speed going downhill: this could
If the machine is transported on a truck or trailer, use ramps
4.32), to use the braking effect
27
EN