Interventions On The Machine - Sabo 92-13 HF Manual Del Operador

32
EN

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck
alignment
The cutting deck should be
properly set to obtain a good
cut.
If the cut is uneven, check the
tyre pressure.
If this is not sufficient to
achieve an even cut, please
contact your Dealer for the
adjustment of the alignment of the cutting deck.
6.3.2 Replacing wheels
Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels are held by a snap ring (1) which can
be eased off with a screwdriver.
NOTE
or both rear wheels, make sure that any differ-
ences in their external diameter does not
exceed 8-10 mm; on the contrary, to prevent an uneven cut it will be necessary to
adjust the alignment of the cutting deck.
IMPORTANT
snap ring (1) and supporting washer (2) back in place.
6.3.3 Replacing and repairing the tyres
The tyres are "Tubeless" and so all punctures must be repaired by a tyre repairer fol-
lowing the procedures required for this kind of tyre.
If you have to replace one
Before remounting the wheel, apply grease to the axle. Put the
MAINTENANCE
2 1