WARNING (continued)
•
To reduce the risk of fire or electrical shock, do not use this fan with any solid state fan speed
device or variable speed control.
•
Do not touch hot LED
•
The LED light output is strong enough to injure human eyes. Precautions must be taken to
prevent looking directly at the LEDs with unaided eyes for more than a few seconds.
CAUTION:
•
Read and understand all instructions and illustrations completely before proceeding with assembly
and installation of this fixture.
•
If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a qualified licensed electrical contractor.
•
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts
out, or use any parts that are worn out or broken. Failure to obey this instruction could invalidate
the UL listing, C.S.A. certification, and/or ETL listing of this fixture.
•
This fixture is intended for installation in accordance with the National Electric Code (NEC) and all
local code specifications.
•
Use ONLY the supplied LED driver to power fixture.
•
Driver cable is not intended for use through or concealed behind walls, floors, or ceilings.
•
This fixture is for indoor use only.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated assembly time: 30 minutes to 1 hour.
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire strippers,
electrical tape, ladder, safety glasses.
ASSEMBLY INSTRUCTIONS
•
WARNING-To reduce risk of fire, electric shock, or personal injury, mount to outlet box marked
"Acceptable for Fan Support of 15.9kg (35lbs) or less" and use mounting screws provided with the
outlet box and/or support directly from building structure. Most outlet boxes commonly used for
the support of luminaries are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
•
Warning-Risk of fire, electric shock, or personal injury. Ceiling fans may be either directly
supported from a structural framing member of a building and (see examples in figures A & B) or
may be mounted to an outlet box marked acceptable for fan support of 31.8 kg (70 lbs) to 15.9kg
(35 lbs) (see example in figure C).
A
B
4
C