Receiving And Storage - WEG CFW700 Serie Manual Del Usuario

2.6 RECEIVING AND STORAGE

The CFW700 comes packaged in a cardboard box up to size C inverter models. The bigger
models are packed in wooden box. There is an identification label affixed to the outside of this
package, the same one that is affixed to the side of the CFW700 inverter.
Follow the steps below to open the packaging of models larger than size C:
1 - Put the shipping container over a flat and stable area with the assistance of another two
people;
2 - Open the wood crate;
3 - Remove all the packing material (the cardboard or styrofoam protection) before removing
the inverter.
Check the following items once the inverter is delivered:
Verify that the CFW700 nameplate corresponds to the model number on your purchase order;
Inspect the CFW700 for external damage during transportation.
Report any damage immediately to the carrier that delivered your CFW700 inverter.
If CFW700 is to be stored for some time before use, be sure that it is stored in a clean and dry
location that conforms to the storage temperature specification (between -25 °C and 60 °C (-13
°F and 140 °F)). Cover the inverter to prevent dust accumulation inside it.
ATTENTION!
Capacitor reforming is required if drives are stored for long periods of time
without power. Please follow the procedure at item Preventive Maintenance in
the Programming and Troubleshooting Manual of the CFW700.
- English -
General Instructions
CFW700 | 13