Steps For Using The Quick Start Programs - Welby TEN 603 Manual Del Usuario

4. Adjust the pulse width:
You can also select a pulse width
from 50 μs to 250 μs using the
intensity button (Fig. 10, example
program TENS 28). Confirm your se-
lection with the
tinue to select the treatment length.
5. Set the treatment length:
Press the intensity button to select a
treatment duration between 5 and
100 minutes (Fig. 11, example pro-
gram TENS 28).
Press the
your selection and deactivate pro-
gramming mode.
6. Start and finish the treatment by following steps 5 through
7 in the previous chapter.

Steps for using the quick start programs

There are 3 quick start programs (Pb1, Pb2 and Pb3) in both
TENS and EMS mode for the neck, lower back and knee areas.
The quick start programs are selected with the following
buttons:
• button: Neck
12
• button: Lower back
11
• button: Knee
10
1. Position the electrodes
ple near the pain area on the neck, and switch on the de-
vice. Switch on the device by pressing the
button and con-
button to confirm
9
4
on the desired area, for exam-
Application
Fig. 10
Fig. 11
button .
9
35