SATA air vision 5000 Instrucciones De Servicio página 113

Insert head straps in the hood
shell
Notice!
For different head sizes, the
front assembly flaps on the hood
shell can be locked in 2 posi-
tions (Pos. 1, Pos. 2). These
positions have two lock settings.
The rear assembly flaps have
two rows each (Pos. 1, Pos. 2)
to set the angle of the breathing
protection hood.
■ Insert the front assembly flaps
at position 1 or 2 and lock them in
place completely.
■ Fasten the rear assembly flaps
in position 1 or 2 on the pin of the
hood shell.
Check seating position of the
breathing protection hood
■ Put on the breathing protection hood
with open visor.
■ Check the settings of the head straps
and correct them if necessary.
■ Close the visor.
Notice!
The facial seal must be in con-
tact with the entire facial contour
and the field of vision may not
be impaired by the visor (e.g. for
men with beards). If this is not
the case, a correction must be
carried out at the front or rear
assembly flaps [5-1],[5-3], the
head band [5-2] or the adjusting
screw [5-4].
Operating Manual SATA Breathing Protection System
Attach hood cloth
The tissue properties of the cov-
er sheet correspond to DIN EN
14116 index 1 (protection against
heat and flame) as well as DIN
EN 1149-3 (electro-static prop-
erties). Protective material prop-
erties can change after 5 wash
processes (chemical cleaning).
■ Align the hood cloth
[5-1]
■ Fasten the velcro fasteners
[5-3]
■ Insert the hood cloth in the groove at
■ Fasten the velcro fasteners
■ Thread the breathing air tube through
9.2. Control operation of the
Before any use, check the following
points to ensure safe work with the
breathing protection hood.
■ Adhere to all safety and hazard warn-
■ Air supply operating pressure.
■ Fasten hood cloth properly.
■ Ensure the hood cloth is undamaged
■ Ensure the vision through the visor is
■ Only use intact SATA safety com-
■ Breathing protection hood is properly
Notice!
[1-20]
central marking
middle visor bolt.
the visor.
the transition to the visor.
the breathing protection hood.
the breathing air tube strap
breathing protection
hood
ings in this operating manual.
and clean.
unimpaired.
pressed air tubes.
seated.
[1-15]
with the
on the top
[1-21]
to
[1-16]
to
[1-17]
.
EN
113