Corghi ProLine 650 Manual De Uso página 63

- Press the
machine for entering the nominal wheel
diameter.
- Read the rated rim diameter value on the
tyre.
- Modify the value displayed on the right
display by pressing the
keys to get the previously measured nomi-
nal diameter.
- Press to display the imbalance
a
User manual ProLine 650
14a
key again to set the
b
d
values (recalculated for the new dimen-
sions) or perform a wheel spin.
Balancing weight application
- Select the plane where the first balancing
weight is to be applied.
- Turn the wheel until the central element of
the corresponding position indicator lights
up.
If the weight to be applied is a conventional
clip type(inner side in Alu 2P), apply it on the
corresponding 12 o'clock position.
If the weight to be applied is self-adhesive,
proceed as follows:
VERSION WITH AUTOMATIC SENSOR
- Position it inside the cavity of the weight-
holder terminal of the measuring arm (Fig.
15,a,b), with the backing paper of the
adhesive strip facing up. Then remove
the guard (Fig. 15c).
- Move the sensor until it reaches the indi-
cated position. In this phase, one display
continues to show the unbalance value
of the side to be balanced, while the
other shows a numerical value updated
on the basis of the sensor position, which
becomes zero when the position for ap-
plication of the weight is reached.
c
e
15
63
UK