Transport For Installation/Dismantling Purposes - Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento

English
3.2 Transport for installation/
dismantling purposes
Fig. 8: Transporting the pump
Fig. 9: Transport of the motor impeller unit
6
WARNING! Risk of injuries to personnel!
Incorrect transport can cause injury to personnel.
• The pump must be transported using approved load-bearing equip-
ment (e.g. block and tackle, crane, etc.). These are to be attached to
the transport eyes at the motor flange (Fig. 8, shown here: lifting
direction with vertical motor shaft).
• If necessary, e.g. in case of repairs, the transport eyes can be moved
from the motor flange to the motor housing (see e.g. Fig. 9). Before
installing the transport eyes at the motor housing, unscrew the
spacers from the openings for the transport eyes (Fig. 7, Item 20b)
(see chapter 10.2.1 "Replacing the mechanical seal" on page 50).
• Before using the transport eyes, check the eyes for damage and ensure
that the fastening screws are completely screwed in and tightened.
• If the transport eyes have been moved from the motor flange and
installed at the motor housing, then they are only approved for car-
rying or transporting the motor impeller unit (Fig. 9) and not for
transport of the whole pump and not for separation of the motor
impeller unit from the pump housing.
• If the transport eyes are moved from the motor flange to the motor
housing, e.g. in case of repairs (see chapter 10 "Maintenance" on
page 48 ), then these are to be reattached to the motor flange after
completion of the installation or maintenance work and the spacers are
to be screwed into the openings of the transport eyes (Fig. 7, Item 20a).
WILO SE 01/2014