Symbols In Graphics/Instructions; Display Modes - Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento

8.4

Symbols in graphics/instructions

Menu elements
Actions
8.5

Display modes

Display test
max
min
2
Fig. 31: Display test
Installation and operating instructions Wilo-Stratos GIGA
Chapter 8.6 "Operating instructions" on page 34 contains graphics
that illustrate the operating concept and provide instructions for con-
figuring settings.
In the graphics and instructions, the following symbols are used as
simple representations of menu elements or actions:
• Menu status page: Standard view on the display.
12.3
• "One level down": A menu element that can be used to jump to a
4.1.0.0
lower menu level (e.g. <4.1.0.0> to <4.1.1.0>.
• "Information": A menu element that shows information about the
4.4.3.0
device status or settings that cannot be changed.
±
• "Selection/setting": A menu element that provides access to a
2.0.0.0
changeable setting (element with menu number <X.X.X.0>).
"One level up": A menu element that can be used to jump to a higher
menu level (e.g. <4.1.0.0> to <4.0.0.0>.
Menu error page: In the event of an error, the current error number is
E000
displayed instead of the status page.
• Turn red button: Turn the red button or increase or decrease settings
or menu numbers.
• Press red button: Press the red button to activate a menu element or
confirm a change.
• Navigate: Perform the steps that follow to navigate in the menu to
the displayed menu number.
• Wait time: The remaining time (in seconds) is displayed on the value
display until the next state is reached automatically or manual input
can be made.
ON
• Set DIP switch to the OFF position: Set the DIP switch number "X"
under the housing cover to the 'OFF' position.
X
ON
• Set DIP switch to the ON position: Set the DIP switch number "X"
under the housing cover to the 'ON' position.
X
As soon as the power supply of the electronic module has been estab-
lished, a 2-second display test is carried out, during which all charac-
ters on the display are shown (Fig. 31). Afterwards the status page is
displayed.
After interruption of the power supply, the module carries out various
shut-off functions. The display will be shown for the duration of this
process.
DANGER! Danger of death!
There can be electrical charges present in the display even if is
switched off.
• Observe general safety instructions!
English
31