Franklin Electric SUBMONITOR CONNECT Manual De Instalación Y Funcionamiento Del Propietario página 21

Mod Menu / Parameter
RW RC
bus
Ground Fault Menu
424 RW N Trip/Alarm
425 RW N Current Level
No Current
426 RW N Trip/Alarm
Unexpected Current
427 RW N Trip/Alarm
Out of Calibration Menu
428 RW N Trip/Alarm
Max Start Time Menu
429 RW N Trip/Alarm
Programming: Advanced Setup > Motor Protection > Voltage
Mod
RW RC Display Name
bus
Overvoltage Menu
432 RW N Trip/Alarm
433 RW N Overvoltage Level 101 to 125; default = 110
430 RW N Nominal Voltage
431
434 RW N Time to Trip
435 RW N Fault Reset Type
436 RW N Reset Retries
437 RW N Reset Delay
Undervoltage Menu
438 RW N Trip/Alarm
439 RW N Undervoltage
Level
430 RW N Nominal Voltage
431
Range
Name
0 - Off
1 - Fault and Alarm (default)
2 - Alarm only
1 A to A; default = 1.0 A
0 - Off (default)
1 - Fault and Alarm
2 - Alarm only
0 - Off (default)
1 - Fault and Alarm
2 - Alarm only
0 - Off
1 - Fault and Alarm (default)
2 - Alarm only
0 - Off (default)
1 - Fault and Alarm
2 - Alarm only
Range
0 - Off
1 - Fault and Alarm (default)
2 - Alarm Only
120.0 to 7,200.0;
default = 208.0 multi = 0.1
1 to 120; default = 10
0 - Manual
1 - Automatic (default)
1 to 10; default = 3
1 to 43,200; default = 900
0 - Off
1 - Fault and Alarm (default)
2 - Alarm Only
75 to 99; default = 90
120.0 to 7200;
default = 208.0 multi = 0.1
Programming: Advanced Setup > Motor Protection > Voltage
Choose the type of response for ground fault current pro-
tection.
Amount of ground fault current that will trigger a fault
condition.
Choose the type of response for no current detected
when current is expected.
Choose the type of response for when unexpected cur-
rent is detected.
Choose the type of response when the measured peak
inrush current is outside of the range of 400% to 1400%
of the user-set FLA.
Choose the type of response for when the start time for
the motor is exceeded.
Overvoltage Protection Enable
Overvoltage Level Percentage
Nominal Voltage setting
Overvoltage Delay Time in seconds
Overvoltage Reset Method
When automatic reset is enabled, this sets how many
times to attempt resetting the fault.
The number of seconds between automatic resets.
Undervoltage Protection Enable
Undervoltage Level Percentage
Nominal Voltage setting
INSTALLATION AND SETUP
Description
Description
21