Franklin Electric SUBMONITOR CONNECT Manual De Instalación Y Funcionamiento Del Propietario página 24

INSTALLATION AND SETUP
Programming: Advanced Setup > I/O Terminals (MT1311/MT2211 only)
Mod
RW RC Display Name
bus
471 RW N Fault Reset Type
472 RW N Reset Retries
473 RW N Reset Delay
False Start menu
474 RW N Trip
475 RW N Fault Reset Type
476 RW N Reset Retries
477 RW N Reset Delay
Cycle Fault menu
478 RW N Trip
Motor Over Temp menu
479 RW N Trip/Alarm
480 RW N Sensor Type
481 RW N Trip Temp
482 RW N Alarm Temp
483 RW N Time to Trip
484 RW N Fault Reset Type
485 RW N Reset Retries
486 RW N Reset Delay
Programming: Advanced Setup > I/O Terminals
Mod
RW RC Display Name
bus
518 RW N D1 Contact Type
520 RW N D2 Contact Type
524 RW N D1/D2 Function
505 RW N Control Input
For further information regarding D1/D2 use, refer to
24
Range
0 - Manual (default)
1 - Automatic
1 to 10; default = 3
1 to 43,200; default = 900
0 - Disabled (default)
1 - Enabled
0 - Manual (default)
1 - Automatic
1 to 10; default = 3
1 to 43,200; default = 900
0 - Disabled
1 - Enabled (default)
0 - Off (default)
1 - Fault and Alarm
2 - Alarm Only
0 - PT100 (default)
1 - PT1000
0 to 200; default = 40
0 to 200; default = 30
1 to 120; default = 5
0 - Disabled (default)
1 - Enabled
1 to 10; default = 3
1 to 43,200; default = 900
Range
Normally Open (default)
Normally Closed
Normally Open
Normally Closed (default)
Auto run / Shutdown
(default)
LO/HI Fill Mode
LO/HI Drain Mode
HOA (default)
HOA W/ Start pushbutton
Start/Stop pushbuttons
"Fill/Drain using Float Switches" on page
Description
SubTemp Reset Method
SubTemp Automatic Reset Attempts allowed
SubTemp Automatic Reset Delay Time in seconds
False Start Protection Enable
False Start Reset Method
False Start Automatic Reset - Number of Attempts
False Start Automatic Reset Delay Time in seconds
Choose the type of response for when a cycle fault condi-
tion is detected.
RTD Over Temperature Protection Enable
Set the Type of RTD Sensor used
Temperature in °C to Trip a RTD Fault
Temperature in °C to Trip a RTD Alarm
Delay Time in seconds for RTD Fault/Alarm
RTD Over Temperature Reset Method
Number of Automatic Reset Attempts for RTD Over Tem-
perature Fault/Alarm
RTD Over Temperature Automatic Reset Delay Time in sec-
onds.
(MT1311/MT2211 only)
Description
Choose the intended function of the switch connected to
D1 and SG.
Choose the intended function of the switch connected to
D2 and SG.
Choose the type of action the switches connected to D1
and D2 perform.
Choose the Pilot device type
27.