Kyosho Mini-Z Racer MR-03 Manual De Instrucciones página 69

Ocultar thumbs Ver también para Mini-Z Racer MR-03:
Tabla de contenido

Publicidad

TROUBLE SHOOTING
Problem /
症状
Doesn't Run Straight
まっすぐ走らない
Doesn't Stop
止まらない
Running Too Slowly
スピードが出ない
Other
その他
こ の 他 に も 走 行 場 所 や 時 間 帯 に よ っ て 電 波 の 到達 距 離 や 精 度 が 変 化 し 操縦できなくなる場合 があります。
こ の 様 な 時 に は 、 当 社 ユ ー ザ ー 相 談 室 ま で ご 連絡 く だ さ い 。
/ 故障かな・・!?
Cause /
原因
Steering Trim is not adjusted correctly.
ステアリングトリムの調整が正しくない。
Front and Rear Wheel Nuts are too tight.
前後輪のホイールナットをしめすぎている。
Throttle Trim is not adjusted correctly.
スロットルトリムの調整が正しくない。
Batteries have run down.
電池の残量が少ない。
Motor has lost power.
モーターが劣化してきている。
Front and Rear Wheel Nuts are too tight.
前後輪のホイールナットをしめすぎている。
Dust or foreign objects are inside gears.
ギヤにホコリや異物がはさまっている。
Sound goes from chassis.
車体から音が出ている。
Correction /
Make adjustment as per Instruction
Manual P22.
説明書22ページに従って正しく調整する。
When tire rotation seems too tight, please
loosen slightly.
タイヤの回転がきつい時は少しゆるめてください。
Make adjustment as per Instruction
Manual P22.
説明書22ページに従って正しく調整する。
Change batteries as per Instruction
Manual P16.
説明書16ページに従って確認し新しい電池に交換する。
Change to spare motor as per Instruction
Manual P46-57.
説明書46~57ページに従ってスペアモーター
に交換する。
Tighten Wheel Nuts as per Instruction
Manual P15.
説明書15ページに従って正しくしめなおす。
Turn the power switch OFF and clean out
Gears.
車体のスイッチをOFFにし、すぐに異物を取り
のぞく。
Due to high performance digital servo some
vibration may occur. This is not a fault
高性能デジタルサーボを搭載しているため振動
する事がありますが走行に問題はありません。
69
対処

Publicidad

Tabla de contenido
loading

Tabla de contenido