Detergent System Purge - Nilfisk Liberty SC50 Instrucciones De Uso

6/2020

DETERGENT SYSTEM PURGE

To Purge When Changing Detergent (SCRUB AND SOLUTION SYSTEMS MUST BE OFF):
SERVICE NOTE: Move machine over floor drain before purging because a small amount of detergent will be dispensed in the process.
1 Disconnect and remove the detergent cartridge.
2 Place the Magnetic SmartKey (Z) onto SmartKey Reader (A). Press the Power Switch (B) to power ON machine. Wait a few seconds for the
start-up sequence to finish.
3 Press and hold the Solution Switch (J) and the Detergent Switch (K) down for 2 seconds. Release the switches when the Detergent Purge
Indicator (X17) appears on the display (the Detergent Switch Light (K1) and Solution Switch Light (J1) will be ON). NOTE: Once activated
the purge process takes 20 seconds (timer countdown will display). Press (J) and (K) again before 20 seconds to cancel purge. See
illustration on next page for Detergent System indicators. Normally one purge cycle is adequate to purge the system.
To Purge Weekly (SCRUB AND SOLUTION SYSTEMS MUST BE OFF):
1 Disconnect and remove the detergent cartridge. Install and connect a Cartridge filled with clean warm water.
2 Follow steps 2 and 3 from "To Purge When Changing Detergent".
When the detergent level is nearing the bottom of the cartridge it is time to refill or replace the cartridge.
SERVICE NOTE: Follow the "To Purge Weekly" instructions above if the machine is going to be stored for an extended period of time.
FIGURE 2-9
Purge
Press and hold (J) & (K)
for 2 seconds to purge.
12/2017
PURGING
Please wait . . .
AA
B
3
A
Z
INSTRUCTIONS FOR USE
20
X
J
J1
K1
CB1 CB2
K1
5A 5A
56091204 - Nilfisk Liberty SC50
ENGLISH - A
X17
K
O
CB3
15A
Y
Y1
A - 31