► Observe the maintenance recommendations.
NOTICE
Thermal overloading of the product
Damage due to improper thermal treatment
► Do not carry out any heat treatment at temperatures above 300 °C
(570 °F).
► Prior to thermal treatment, remove all temperature-critical components
(such as plastic parts).
NOTICE
Thermal overloading of product components
Loss of function due to improper thermal treatment
► Prior to the thermal treatment of the product, remove all temperature-
critical components (e.g. plastic parts).
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C (14 °F) or
above +60 °C (140 °F) (e.g. sauna, excessive sunlight, drying on a
radiator).
5 Preparation for use
INFORMATION
The instructions for fabricating an orthosis with unilateral joints are
included in the 646T5=5441 technical information. The laminate structure
described here is a recommendation from Ottobock and must be adjusted
to the needs of the patient.
18