Adding Your Pet To The Feeder - SURE petcare SureFeed Manual Del Usuario

Adding your pet to the Feeder

When adding your pet's microchip ID into the Microchip Pet Feeder Connect, make sure all
other pets and any unrequired collar tags are kept out of the way.
1
Press the 'Add a pet' ( ) button found
at the rear of the Feeder.
3
Put some food/treats into the bowl
and place the Feeder where you would
normally feed your pet.
5
When your pet moves away, the lid will
close and the green LED will turn off. Their
microchip ID is now permanently stored.
To program a pet's microchip ID, sensors located in the hoop of the Feeder must
detect the pet's presence. Therefore it's important to ensure your pet places their
head through the hoop to eat.
To program a Sure Petcare RFID Collar Tag, simply follow the steps above but hold
the collar tag inside the hoop. Make sure you are not wearing any metal jewellery
when programming a collar tag.
If you already have a pet in your Sure Petcare household, it is possible to assign
them to the Feeder. Go to the Household section of the app. If you add the wrong
pet by mistake you can always correct it here.
15
2
The lid will open and the rear LED will
flash green once every second.
4
Whilst your pet eats, the Feeder scans their
microchip ID. Once the ID has been added,
the LED will stop flashing (but remain on).
If you need to, you can cancel the 'Add a pet'
mode at any time with a second press of the
'Add a pet' ( ) button.