Replacing The Fuse On The Power Socket; De-Commissioning - Hill-Rom Primo P02033 Manual De Usuario

PROPRIETARY AND CONFIDENTIAL DRAFT: octobre 11, 2012

Replacing the fuse on the power socket

fuse
1. Disconnect the device.
2. Remove the power cord of the connector.
3. Remove the fuse box located on the power socket using a small
screwdriver.

Check that the new fuse matches the characteristics on the label and meets the
IEC 60269-1 standard.
4. Replace the old fuse.
5. Securely close the fuse box.

Two others fuses are located on the alimentation card.
Refer to the Primo
If the problem is not solved, contact your local Hill-Rom representative (see back of
manual). Indicate the serial number of the device, which can be found on the
control unit, when requesting repairs.

De-commissioning

The device and its accessories should be cleaned and disinfected before de-
commissioning.
Decommissioned equipment materials (plastics, electrical components,
etc.) must be recycled in accordance with local recycling regulations.
Always meet the applicable demands and local rules relating to
environmental protection, in particular for waste from medical devices.
Do not dispose of electric and electronic equipment in the waste bin (as
per directive 2012/19/EU).
Never discard the batteries or accumulators of your device. They may
contain substances and metals that are hazardous for the environment
and health (as per Directive 2006/96/EC).

Refer to the Primo
instructions.
Page 32
Service Manual for replacement.
™
Service Manual for detailed battery replacement
™
170924(2) - EN - Primo User Manual
™