Festo DGE-25-ZR-RF Instrucciones De Utilizacion página 38

DGE−...−ZR−RF
Fitting centre supports
Position the centre supports equally over
S
the entire length of the cylinder, not just
over the stroke length.
Fasten the centre supports on the
S
DGE−...−ZR−RF as shown in Fig. 20.
If tilted, the sliding blocks of the centre
supports will slide into the groove at any
point on the profile.
Make sure that the centre supports are
S
outside the positioning range of the slide
by pushing it once over the complete posi
tioning path.
Tighten the fastening screws to an equal
S
extent.
38
40
63
Fig. 20
Fig. 21
Festo DGE−...−ZR−RF 0405a English
Ø 25