Festo DGE-25-ZR-RF Instrucciones De Utilizacion página 52

DGE−...−ZR−RF
Fault
Missing or
undefined
switching functions switching functions
Jamming
Permitted
dynamics not
reached
Locking in"
at one position
Vibration
Motor speed
cannot be
transmitted to transmitted to
product
Fig. 46
52
Possible cause
Proximity switch or cable defective Fit new proximity switch or
Incorrect mounting of sensor
support or switching cam
Switching interval set incorrectly
Incorrect switch or incorrect
connection
Extreme accumulation of dirt
under toothed belt
Axis badly damaged due to crash
or similar
Outside the axis (e.g. drive
package including coupling or
external attachments)
Incorrect toothed belt
pre−tensioning e.g. due to belt
damage
Long standstill time at one
position
Overloading the axis
Dynamics too high
Incorrect placing of centre of
gravity of work load
External coupling on the base
stand or in the multi−axis system
Coupling loose
Toothed belt torn or teeth torn off
Remedy
replace cable
Carry out settings again
Readjust
Use correct switch or
connection
Eliminate cause and return
product to Festo
Return product to Festo
See instructions
Return product to Festo
Disappears after a running
in phase
Observe maximum loading
limits
If necessary, check
modifications to plan
Shift centre of gravity
Eliminate coupling in
Tighten locking screws of
coupling
Return product to Festo
Festo DGE−...−ZR−RF 0405a English