The 4-Channel Radio Command Unit - Carson CESSNA 182 Manual De Instrucciones

4-CHANNEL RADIO CONTROL UNIT
GB GB
Your almost-ready-to-fly Cessna 182 set includes
a 4-channel radio control unit, receiver and flight
controller already installed in the Cessna 182, as
well as 4 micro-servos to operate the rudder and
elevator. This system is designed to have a range
of 300m which means that you can control your
aeroplane up to this distance. In practice, normal
Assignment of Transmitter Identifier to Receiver (Binding)
During remote control operation, an electronic
identifier is transmitted with each transmission
pulse in addition to the control information. Based
on this identifier the receiver identifies that the
signal is from "its" transmitter. As there are many
millions of transmitter identifiers available, it is
extremely unlikely that a foreign transmitter will be
able to affect your receiver. However, the
transmitter must communicate this identifier once
to each new receiver prior to the initial start-up.
This requires the following procedure which where
possible should be carried out in a place where
this transmission by radio cannot be disrupted by
any other electrical signals, particularly not by
other 2.4 GHz transmitters.
ETB41 - 2.4 GHz ETB41 - 2.4 GHz
Frequency alignment button
10 CESSNA 182 CARSON R/C MODEL AIRCRAFT
DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM
ON ON
1 1 2 2 3 3 4 4
REV REV
NOR NOR
OFF OFF
flying will be conducted at a closer distance in
order to see the flight attitude of the model.
Never start when batteries in the transmitter are
weak (voltage indicator in red area) otherwise your
Cessna 182 could fly away out of control.
1. Arrange transmitter and receiver side-by-side
and close together in working order but
switched off. To assign the receiver to the
transmitter, press the frequency alignment
button on the transmitter and switch on the
transmitter.
2. Insert the short-circuit connector (see diagram
below) into the "BATT" socket on the receiver.
Connect the flight controller to the receiver and
the flight battery to supply the receiver with
power and this should light up the indicator light.
3. If the frequency alignment was successful, the
indicator light will continue to be lit up. 4.The
indicator light will start flashing when the short-
circuit connector is removed. The receiver goes
into the ready to operate mode.
5. Press the frequency alignment button again for
acknowledgement. The transmitter is now ready
to operate and the indicator light lights up
indicating normal function of the receiver.
Short-circuit connector
50 050 5017