Logan F300-1 Manual De Instrucciones página 5

Instruction Manual
Preparation
A. Choose V-nail type, size and quality
1. V-nail Type
a. Hard Wood Nails - Used for very hard woods
like oak and maple. Do not use on soft
woods.
b. Soft Wood Nails - Used specifically for soft
woods but can be used on hard woods.
2. V-nail Size
a. Choose a size nail that is at least 1/2 the
moulding thickness.
3. Quality
a. Use at least two V-nails per joint.
1/4" to 1 3/4" wide moulding - 2 nails
2" to 2 1/2" wide moulding - 3 nails
For information on how to purchase additional
V-nails see page 10.
B. Clamp Moulding
• Mark edge of miter to blend any gaps
in corner (Fig. 5) using a stain marker.
Stain markers can be purchased at a
hardware store.
• Glue moulding miter for long lasting
solid corners (Fig. 6).
1. Adjust clamp jaw by pressing spring
button and sliding handle (Fig. 7).
2. Align moulding pieces in vise so top
corner is square (Fig. 8).
3. Do not overtighten. The moulding only
requires enough clamping pressure to
hold it still (Fig. 9).
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
Studio Joiner
Fig. 5
Fig. 9
Model F300-1
Fig. 6
Fig. 7
Fig. 8
4