Settings On The Printed Circuit Board; Calling Up Menu For Making Changes; Selecting Menu Item; Quitting Menu For Making Changes - Kärcher SB-HDW S 1 Manual De Instrucciones

English
B Operating information and
settings
B 6
Operating Instructions

2.3. Settings on the printed circuit board

The following functions are set on the printed circuit board:
n Washing times
n Amount of detergent metered
n Washing programme with hot or cold water
n Coin value of the coin-acceptor unit.

2.3.1. Calling up menu for making changes

To change settings, switch display from washing time-credit
to changing menu .
For this purpose press down red button on printed circuit
board for approx. 2 seconds.
The following appears on the display:
1 signifies menu item 1.
xx is the value set in menu item 1.

2.3.2. Selecting menu item

A brief press on the red button gives the next menu item.
After the last menu item, menu item 1 is shown again
(continuous process).
2.3.3. Changing the value of the menu item
A brief press on the white button increases the value of the
menu item selected. A long press starts a fast run-through.
After the final value, the indicator jumps back to the
beginning (continuous process).

2.3.4. Quitting menu for making changes

a. without storing
Do not operate a button for the duration of one minute. The
display will switch back to washing time-credit.
b. to include storing
A long press (approx. 2 seconds) on the red button stores
the changed value. When the display changes to washing
time-credit, the storing process has been accomplished.
i
Important!
Having stored the values, briefly switch the system off and
then on again so that the printed circuit board takes over
the new values.
SB-HDW S 1 / SB-HDW S 2
1=xx