Tabla De Contenido - Dräger Polytron 5000 Serie Instrucciones De Uso

Contents
®
Dräger Polytron 5000 Series
Safety-related information
Safety statements
Operating area and conditions
Mechanical installation
Electrical installation
Commissioning
Calibration
During operation
Maintenance
Conventions in this document
Meaning of the warnings
Typographical conventions
Trademarks
Description
Product overview
Feature description
Configuration possibilities
Interfaces
Explosion protection
Intended use
Approvals
ATEX, IECEx, UL, CSA
Marking
Explosion proof (Ex d) installation - without
Docking Station
Mechanical installation without Docking Station
Electrical installation without docking station
Wiring tables
Figures on the fold-out page
Preparing the electrical installation
Connecting the instrument as stand-alone
Electrical connection of relay option
Connecting the 4-20mA interface
Grounding
Closing the instrument
Increased safety (Ex e) installation - with
Docking Station
Mechanical installation with Docking Station
Electrical installation with docking station
Installation of sensors
Installing EC sensor
Commissioning of the instrument
Operation
Display, analog interface and relay status
Measuring mode
Special states
Ending special states
LED and symbol indications
Menu
Menu navigation
Password
Dräger Polytron
®
5000 Series
Entering the menu
Changing parameter values / status
Exiting the menu
Displaying the firmware version
Calibration
Test gases
Preparation of Calibration
Preparing calibration set-up
Gas flow for calibrations
Zero calibration
Performing zero calibration
Span calibration
Performing span calibration
Troubleshooting
Faults
Warnings
Maintenance
Sensor replacement
®
Polytron 5100 EC
®
Polytron 5200 CAT, 5310 IR, 57x0 IR
Displaying error codes
Checking response time (t90)
Instrument settings
Combinations of latching and acknowledgment of
alarms
Relays
Configuring relay A1 or A2
Setting fault relay warm-up 1
Alarms
Alarm hysteresis
Configuring alarms
Testing alarms/relays
Configuring the password
Switching the Display (LCD) On/Off
Setting 2-wire/3-wire configuration
Interface settings
4-20mA interface
Full scale deflection
Setting maintenance signal
4-20 mA offset
Testing the analog interface
Sensor settings Polytron
Setting Full scale deflection
®
Sensor settings Polytron
Changing the Gas Category
Sensor type
®
Sensor settings Polytron
Setting LEL type
Setting the target gas
Setting gas unit
Switching the PIR Lock On/Off
Contents en
®
5xx0
5200 CAT / 5310 IR
57x0 IR