Descargar Imprimir esta página

Transport; Maintenance/Cleaning - Bosch Active Line Serie Manual Original

Publicidad

Idiomas disponibles

Idiomas disponibles

English–11
– "
Service MM/YYYY": This menu item is displayed
when the bike manufacturer has set a fixed service ap-
pointment.
– "
Serv. xx km/mi": This menu item is displayed
when the bike manufacturer has set a fixed service ap-
pointment after a certain mileage has been reached.
– "Bat. vx.x.x.x": This is the software version of the bat-
tery pack.This menu item is displayed only when the on-
board computer is in the holder.
– "1. Bat. vx.x.x.x": When using 2 battery packs this is
the software version of one of the battery packs. This
menu item is displayed only when the on-board comput-
er is in the holder.
– "2. Bat. vx.x.x.x": When using 2 battery packs this is
the software version of the other battery pack. This
menu item is displayed only when the on-board comput-
er is in the holder.
– "Gear vx.x.x.x": This is the software version of the au-
tomatic transmission. This menu item is displayed only
when the on-board computer is in the holder. This menu
item is displayed only in conjunction with an automatic
transmission.
Power Supply for External Devices via USB Con-
nection
With the USB connection, it is possible to operate and
charge most devices whose power supply is possible via a
USB port (e.g., various mobile phones).
A prerequisite for the charging is that the on-board comput-
er and a sufficiently charged battery pack are inserted in
the eBike.
Open the protective cap 8 of the USB port on the on-board
computer. Connect the USB connection of the external de-
vice to the USB port 7 on the on-board computer using the
USB charging cable Micro A – Micro B (available from your
Bosch eBike dealer).
Once the consumer has been disconnected, the USB con-
nection must be sealed again carefully with the protective
cap 8.
 A USB connection is not a waterproof plug-in connec-
tion. When riding in the rain, an external device must
not be connected and the USB connection must be
completely sealed with the protective cap 8.
1 270 U20 XBI | (20.4.16)
118

Transport

 If you carry your eBike outside of your car, e.g. on a
luggage rack, remove the on-board computer and
the eBike battery pack in order to avoid damaging
them. (If the on-board computer cannot be fitted onto a
bracket, it is not possible to remove it from the bicycle.
In this case, the on-board computer may remain on the
bicycle.)
 Always remove the battery pack from the bicycle be-
fore transporting the bicycle on a vehicle bike rack.
Failure to remove the battery pack when using a vehicle
bike rack can lead to death or serious injury. The battery
may detach during transport and cause an accident to
following vehicles.
 Always use an approved and compatible bicycle rack
when transporting your eBike. The Bosch Drive Sys-
tem adds weight to the bicycle. Refer to your bicycle
rack manual to be sure your eBike is compatible. Over-
loading a bike rack can result in death or serious injury.
 Use proper lifting techniques because electric bikes
are generally heavier than bicycles.
Ship batteries only when the housings are undamaged.
Tape or mask off open contacts and pack up the battery in
such a way that it cannot move around in the packaging. No-
tify your parcel service that the package contains danger-
ous goods. Please also follow possibly more detailed na-
tional regulations. Always check the state and federal
regulations before attempting to ship your battery.
In case of questions concerning transport of the battery
packs, please contact an authorized Bosch eBike dealer.
Bosch eBike dealers can also provide suitable transport
packaging.
Bosch eBike Systems

Maintenance/Cleaning

WARNING
 Your Bosch Drive System components are mainte-
nance-free. Do not open any of the components. Ser-
vice should only be carried out at an authorized Bosch
eBike dealer. Failure to follow the above warning may
result in death or serious injury. Refer to your bicycle
manual or component manual for all non-Bosch Drive
System components.
 Always remove the battery pack before performing
any bicycle inspection, maintenance or repair. Fail-
ure to remove the battery pack before performing bicy-
cle inspection, maintenance or repair can lead to seri-
ous injury.
 If you suspect that something is loose, do not ride
your bike. See your Bosch eBike dealer; only a qualified
service provider should perform work on your Bosch
Drive System. All nuts, bolts, screws require the correct
tightening force. Too little force and the fastener may
not hold securely. Too much force and the fastener can
stretch, deform or break, or the threads can be
stripped. Either way, incorrect tightening force can re-
sult in component failure, which can cause you to lose
control and fall.
 Do not paint any components of the Bosch Drive Sys-
tem as this may cause premature failure of the com-
ponents.
Careful Handling of the eBike
Please observe the operating and storage temperatures for
the eBike components. Protect the drive unit, on-board
computer and battery pack against extreme temperatures
(e.g., from intense sunlight without adequate ventilation).
The components (especially the battery pack) can become
damaged because of extreme temperatures.
It is recommended to have your eBike system checked by
an expert at least once a year (including mechanical parts
and to update the system software).
The eBike manufacturer or dealer may also base the service
date on the distance traveled and/or a period of time. In this
case, the on-board computer will show you every time it is
switched on that the service date is due in the text indica-
tion d by displaying "
Service" for 4 s.
Please contact an authorized bicycle dealer for service or
repairs to the eBike.
Bosch eBike Systems
English–12
Cleaning
 Do not submerge your eBike components in water,
or wash using a pressurized hose. Your Bosch drive
unit is designed to be water tight in regards to rain water
and non-pressurized hose washing.
Keep all components of your eBike clean, especially the
battery pack contacts and the corresponding holder con-
tacts.
All components including the drive unit may not be im-
mersed in water or cleaned with a high-pressure cleaner.
Keep all components of your eBike clean, especially the
battery pack contacts and the corresponding holder con-
tacts. Clean them carefully with a soft, damp cloth (using
only mild soap and water).
After Sale Service and Customer Assistance
In case of questions concerning the eBike system and its
components, please contact an authorized Bosch eBike
dealer.
Contact data for authorized Bosch eBike dealers can be
found at www.bosch-ebike.com
When the battery pack is no longer operative, please con-
tact an authorized Bosch eBike dealer.
1 270 U20 XBI | (20.4.16)
119

Publicidad

loading