GASPARDO ALIANTE Empleo Y Mantenimiento página 59

Agitator and support disassembled (Fig. 44). Before proceeding
to re-assemble, thoroughly clean the bearing seats and all the
various parts.
To install the agitator, push it into the opening in the bearing (Fig.
45) ...
.......push the bearing and the protection disc on the left side,
insert the last part of the agitator in the right side (Fig. 46). In the
right hand seat of the bearing, first fit the bearing and then apply
the protection disc on the right, before the matching part of the
agitator (not shown in the figure). Secure the left bearing in its
seat and push the shaft home.
Secure the shaft with the agitator element on the left side (Fig.
47). Then proceed to re-assemble the rest of the parts required
by the agitator.
cod. 19502240
USE AND MAINTENANCE
fig. 44
fig. 45
fig. 46
fig. 47
g
ENGLISH
59