Adjusting The Glideaway Footrests With Optional Calf Supports - Stryker Birthing Bed Manual De Instrucciones

English
Attaching or removing the optional calf supports (Continued)
EN
3. Push the purple button and pivot the footrest into the full upright position (A)
To attach the calf support to the footrest:
1. Pull the pull knob (C)
2. While pulling the pull knob, center the screws on the calf support into the large holes in the footrest plate.
3. Lower the calf support into the footrest plate (B)
4. Release the pull knob into the footrest plate.
To remove the calf support from the footrest:
1. Pull the pull knob (C)
2. While pulling the pull knob, slide the screws on the calf support into the large holes in the footrest plate.
3. Lift the calf support off of the footrest plate (B)
4. Release the pull knob.

Adjusting the Glideaway footrests with optional calf supports

Note: You can make all footrest adjustments (see
supports attached.
1. Grasp the footrest with the optional calf support attached and pull it up and around the foot section
page 1-27).
2. Grasp and attempt to move the footrest to make sure that the footrest is locked in the upright position.
3. Push the purple button and pivot the footrest into the full upright position (A)
1-26
(Figure 1-30 on page
(Figure 1-30 on page
A
Figure 1-30: Attaching the calf supports
Operation
1-26).
(Figure 1-30 on page 1-26).
1-26).
(Figure 1-30 on page 1-26).
Adjusting the Glideaway Footrests on page
4701-209-0 01 REV A
(Figure 1-30 on page 1-26).
1-23) with the optional calf
(Figure 1-38 on
(Figure 1-30 on page 1-26).
www.stryker.com