Ii.LAp Belt Instructions; Jj.INspect - Sunrise Medical Quickie IRIS Manual De Instrucciones

E NG LI S H
II. LAP BELT INSTRUCTIONS
NOTE– Lap belts are fitted as positional aids, and are not suitable as transportation restraints.
Positioning Belt Kit
The positioning belt kit contains: one positioning belt (A), three tri glide buckles (B), two cable ties (C)
1. To assemble the positioning belt, take the positioning belt strap and thread through the tri-glide. Repeat
on both ends of positioning belt.
2. To fit the positioning belt to the chair, take the positioning belt strap and wrap around the back post.
3. Thread the positioning belt back through the tri-glide to form a loop around the back post. Thread posi-
tioning strap through tri-glide as shown.
4. To secure the positioning belt to the chair. Take one of the cable ties supplied and thread through the
positioning belt strap. Then wrap around the frame and fasten together. DO NOT over tighten position-
ing belt. Repeat steps 2-4 with both ends of positioning belt.
5. To adjust the positioning belt use the tri-glide buckles and the fastening buckle.
6. The positioning belt should be adjusted so the fastening buckle is situated in the middle of the stomach.
7. The positioning belt should be adjusted so a hand can be placed between the user and the belt.
The positioning belt must only be fitted by an approved Sunrise Medical dealer/agent. The positioning belt
should only be adjusted by a professional, or a Sunrise Medical approved dealer/agent. The positioning belt
must be checked on a daily basis to ensure it is adjusted correctly (see step 6) and is free from any obstruction
or adverse wear. Sunrise Medical does not encourage the transportation of any person in a vehicle using this
positioning belt as a method of restraint. Please see Sunrise Medical transit booklet for further advice on trans-
portation.
Lap Belt Maintenance
Check lap belt and securing components at regular intervals for any sign of frays or damage. Replace if neces-
sary.
NOTE– The lap belt should be adjusted to suit the end user as detailed above. Sunrise Medical recommends that
the length and fit of the belt be checked on a regular basis to reduce the risk of the end user inadvertently
re-adjusting the belt to an excessive length.
JJ. INSPECT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review assembly and adjustment sections to make sure the chair was properly prepared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting
your authorized supplier, contact Sunrise customer service. See the introduction page for details on how
to contact your authorized supplier or Sunrise customer service.
WARNING
35
IX. DEALER SERVICE & ADJUSTMENT
MK-100151 Rev. D