Transporting And Storage - Brinkmann 810-8410-S Manual Delpropietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BURNER ASSEMBLY/MAINTENANCE CONTINUED
Note:
Follow the "Gas Leak Testing" section of this manual. Relight burners to verify proper
operation.
12. Replace heat distribution
plates and cooking grills.
COOKING GRILLS
Clean with mild soap detergent
and water. A brass bristled brush or a nylon cleaning
pad can be used
to remove residue from the stainless
steel surfaces.
Do not use steel wire bristles to clean the cooking
grills. Steel can cause the finish to chip or crack. DO NOT use a commercial
oven cleaner.
HEAT DISTRIBUTION PLATES
Periodically,
it may be necessary
to inspect and clean the heat distribution
plate to prevent excess
grease build-up.
When the grill is cold, remove the cooking grills. Inspect the heat distribution
plates
and replace if broken or damaged.
Do not allow heat distribution
plates to become damaged
to the
extent that they may fall through
onto the burners. Replace the heat distribution
plates and cooking
grills and light the burners. Operate the grill on "HIGH" for 10 minutes to remove the excess grease.
TRANSPORTING AND STORAGE:
Never move a grill when it is hot or when objects are on the cooking
surfaces.
Make sure that cylinder valve is shut off. After moving the grill check that all gas connections
are free of leaks. Refer to instructions
for Leak Testing.
DO NOT store a spare LP gas cylinder
(filled or empty) under or near the grill.
Never store flammable
liquids or spray canisters
under or near the grill.
DO NOT extinguish
grease fires using water.
If the outdoor cooking
gas appliance
is not in use, the gas must be turned off at the supply
cylinder.
Storage of an outdoor cooking gas appliance
indoors is permissible
only if the cylinder
is
disconnected
and removed from the outdoor cooking
gas appliance.
Cylinders
must be stored outdoors
out of reach of children and must not be stored in a
building,
garage or any other enclosed area.
When removing
the grill from storage, spider webs or other debris may be blocking the burner.
See "Burner
Assembly/Maintenance"
under Proper Care and Maintenance.
t6

Publicidad

Tabla de contenido
loading

Tabla de contenido