Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
connections
and hoses. See the section
on "Leak Testing" in this manual for proper
procedures.
The pressure regulator and hose assembly
supplied
with your gas grill must be used.
•
DO NOT attempt
to connect
it to any other fuel supply source such as a natural gas line.
•
DO NOT use any other pressure regulator/hose
assembly other than the one supplied with your grill.
Replacement
pressure regulator/hose
assembly must be part No 155-2400-0, which can be obtained
by contacting customer service at 800-527-0717.
•
DO NOT attempt
to adjust or repair the regulator. The regulator
is designed
to operate at a
maximum
output pressure of 11 inches of water column (2.74 kPa).
During assembly
and/or replacement
of the gas cylinder,
keep the gas supply hose free of kinks and/or
damage.
Visually inspect the hose assembly
prior to each use for evidence
of damage,
excess wear, or
deterioration.
If found, replace the assembly
before using your grill. Only the manufacturer's
supplied
replacement
should be used.
CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER
Ensure the tank valve is CLOSED
prior to connecting
the LP gas cylinder to your grill. Turn the
valve knob clockwise
to properly
close the valve. Read and follow
all instructions
and warnings
on the supply hose safety tags. Read and follow
all warnings
in this manual concerning
the safe
use of LP gas cylinders
and the hose and regulator before connecting
cylinder to grill. Read
and follow
all warnings
on the LP cylinder.
CONNECTING HOSE AND REGULATOR
1. Check that the cylinder valve is closed by turning the knob clockwise.
2. Check that the grill's burner control knobs are in the "OFF" positions.
3.
Remove the protective
plastic cap from the cylinder valve and the connection
device.
4.
Hold regulator
and insert the nipple of connection
device into the LP cylinder valve outlet. Ensure that
the device is centered
properly.
5.
Turn the large coupling
nut clockwise
by hand and tighten to a full stop. Take care not to cross thread
the coupling
nut onto the cylinder valve. Do not over-tighten
the knob onto the valve. Do not use tools
to tighten connection.
Note:
If you are unable to make the connection,
repeat Steps 4 and 5.
6.
Check that the hose does not contain kinks, does not contact sharp edges, and does not contact
surfaces that may become hot during use.
7.
Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.
Publicidad
Tabla de contenido
