Antriebseinheit; Ec Declaration Of Conformity - ATIKA BAE 30 Manual Original

Fault code
Power pruner picks,
vibrates or does not saw
correctly
Saw chain gets hot
No saw chain lubrication
according to Directive: 2006/42/EG
We
ATIKA GmbH
Josef-Drexler-Str. 8 – 89331 Burgau – Germany
herewith declare under our sole responsibility that the products:
Antriebseinheit (Drive Unit) BAE 30
Benzin-Hochheckenschere (Engine-driven Hedge trimmer) BHH 30 (BAE 30 + BHS 30)
Benzin-Hochentaster (Engine-driven Power Pruner) BKSH 30 (BAE 30 + BHE 30)
Benzin-Freischneider/Grastrimmer (Engine-driven Brushcutter/Grass trimmer) BFSGT 30 (BAE 30 + BFG 30)
Motor-Gartenpflegeset (Engine-driven garden maintenance set) BFGH 30 (BAE 30 + BFG 30 + BHE 30)
Motor-Gartenpflegeset (Engine-driven garden maintenance set) BMGS 30 (BAE 30 + BFG 30 + BHS 30 + BHE 30)
Serial number: 000001 - 020000
are conform with the above mentioned EC directives as well as with the provisions of the guidelines below:
2000/14/EG, 2004/108/EG.
Following harmonized standards have been applied:
EN ISO 11806-1:2011 (Brushcutter / grass trimmer)
EN ISO 10517:2009 (Hedge trimmer)
EN ISO 11680-1:2011 (Power pruner)
conformity assessment procedure: 2000/14/EC - Appendix V
Measured level of the acoustic output L
Guaranteed level of the acoustic output L
Duly authorised person for the complilation of technical documents:
ATIKA GmbH – Technical department – Josef-Drexler-Str. 8 – 89331 Burgau – Germany
Burgau, 24.09.2014
Possible cause
Chain edgeless
Chain worn
Chain not correctly stretched
Chain not assembled correctly (teeth
face to wrong direction)
No oil in the tank
Oil flow canal blocked
Chain tension too high
Chain edgeless
No oil in the tank
Oil flow canal blocked
E C D e c
E C D e c
: 109.8 dB(A).
WA
: 114 dB(A).
WA
Corrective action
Chain must be regrinded or exchanged
Exchange chain
Check and adjust chain tension
Assemble chain again
Refill oil
Clean oil flow canal
Adjust chain tension
Chain must be regrinded or exchanged
Refill oil
Clean oil flow canal
l a r a t i o n o f C o n f o r m i
l a r a t i o n o f C o n f o r m i
i.A.
i.A. G. Koppenstein, Engineering design management
t y
t y
41