SCHUBERTH C3 Manual Del Usuario página 40

D. THE HELMET
Fitting the visor plate
1. Using both hands, guide the visor's
locking studs into the respective
recess in the visor mechanism.
2. The visor will then audibly engage
into place when you press it
gently towards the helmet with a
simultaneous locking movement.
3. Make sure that the visor mechanism
is functioning properly by opening
the visor once to its maximum
extent.
80
CHANGING THE INNER VISOR SHIELD
Removing the inner visor shield
1. Before starting to remove the visor's
inner shield, fi rst lay the visor on a soft,
clean piece of cloth so that its top edge
is facing you.
2. For the purposes of reducing the
pretensioning of the inner shield slightly
if necessary, you can use the balls of
your hands to carefully bend the visor
suffi ciently apart while at the same time
pressing with your thumbs so that the
inner shield becomes released and
moves approx. 2-3 mm forward.
3. Now grasp behind the inner shield with
your index and middle fi ngers and lift it
off the outer shield. In this position you
can now easily remove the inner shield
from the locking pin with your thumb.
4. You can now remove the inner shield
from the visor.
Fitting an inner visor shield
1. Lay the inner shield in the main visor in
such a way that one side of it is already
slotted into the locking pin and the
silicone sealing is on the side facing the
outer visor shield.
81