SCHUBERTH C3 Manual Del Usuario página 43

D. THE HELMET
REPLACING THE SUN VISOR
The sun visor can be replaced without tools.
Tip:
To avoid fi ngerprints and scratches, use a soft, clean cloth
(we recommend a microfi bre cloth) to hold the sun visor when
removing or fi tting it.
Tip:
Changing the sun visor is easier when the chin section is open
and locked in place. It is also helpful if you place the helmet on a
fl at surface or on your thighs while seated.
Note:
Try to prevent the sun visor coming into contact with the helmet
inner shell when removing or fi tting it.
Removing the sun visor
1. Open and lock the chin section in
place.
2. Pivot the sun visor down.
3. Bend the middle snap connection
with locating pegs gently outwards
until the sun visor is released from
the visor holder.
4. Repeat this step for the other side.
Tip:
The sun visor holders should remain in the lower position until you
re-fi t the visor.
86
Fitting the sun visor
1. Put the sun visor between the snap
connections and fi t it onto the
retaining pegs on one side and then
on the other.
2. Position the sun visor between
helmet inner and outer shell and
retract it with the operating slide.
3. To be on the safe side, check
that the sun visor mechanism is
functioning correctly.
87