Visor And Sun Visor - SCHUBERTH C3 Manual Del Usuario

H. MAINTENANCE AND CARE

3. VISOR AND SUN VISOR

®
PINLOCK VISOR
Outer surface of visor
Use a soft cloth and mild soapy water to remove dirt from the outside
of the visor. Use a lint-free cloth to dry the visor.
Inside surface of the visor
The inside surface of the visor should only be cleaned with a soft and,
if necessary, slightly damp cloth (we recommend a microfi bre cloth).
Do not use any cleaning agents for this.
SUN VISOR
The sun visor should only be cleaned with a soft and, if necessary,
slightly damp cloth (we recommend a microfi bre cloth). Do not use
any cleaning agents for this. To protect the anti-fog coating, avoid
vigorous rubbing.
Applicable to all visors:
Note:
After intensive cleaning, riding in the rain or long journeys in
cold weather, the anti-fog coating takes a little time to become
completely effective again. During this time, the coating is unable
to absorb much or any moisture from your breath. You can
accelerate recovery of the coating's anti-fog property by placing
the helmet in a dry, well-ventilated place.
Note:
Use only lukewarm water for cleaning. Never on any account
clean the outer visor or sun visor with petrol, solvent or a window
or glass cleaner or other alcohol-containing cleaning agents.
102
Note:
To protect the anti-fog coating, avoid vigorous rubbing.
Note:
Never apply anti-fog gel, spray or similar substances to the active
anti-fog coating. This can cause undesirable reactions and even
irreparable damage to the coating.
Note:
The active anti-fog coating is subject to an ageing process,
the rate of which depends on the intensity of use and the
environmental conditions. For your own safety, we recommend
replacing the visor shield or sun visor if the anti-fog effect starts
to deteriorate signifi cantly.
Note:
The active anti-fog coating will also absorb chemical substances
such as solvents and can be damaged by them. Therefore, avoid
storing the visor in the vicinity of aggressive substances such as
motor fuels or solvents.
Note:
Even moist lens cloths are often unsuitable for cleaning the
visor – despite recommendations to the contrary – since the
substances they contain are incompatible with the anti-scratch
and anti-fog coating. Avoid using these cloths.
Note:
Do not soak the visor in water (i.e. to soften heavy dirt) as
this can signifi cantly reduce the surface hardness and thus the
resistance of the anti-fog coating.
103