Inner Lining - SCHUBERTH S2 Manual Del Usuario

C. THE HElMET
Fitting the sun visor
1. Put the sun visor between the
snap connections and fi t it on to
the locating pegs on one side and
then on the other.
2. Position the sun visor between
helmet inner and outer shell and
lower it with the operating slide.
3. For safety, check that the sun visor
mechanism is functioning correctly

12. INNER LINING

The replaceable inner lining of the S2 is washable and ensures
both an excellent fi t and improved ventilation of the helmet.
The high-comfort cheek pads ensure that the helmet fi ts
comfortably around the cheeks, and the headband pad provides
an optimal fi t all around the head. The head pad sits comfortably
on the head without covering the ventilation channels (see
Section C. 13, Ventilation systems/Head ventilation).
All parts of the inner lining are made from materials that
are gentle on the skin (especially those that come into direct
contact with the head). The material used for the cheek pads is
Coolmax ® , a soft, breathable material that also conducts heat
and moisture very well, while the headband pad is made from a
special, cooling Thermacool material.
70
Removing the lining
Note:
When removing the lining, the cheek pads must fi rst be
detached before taking out the headband pad. When fi tting
the lining, remember to insert the headband pad before the
cheek pads.
Removing the high-comfort cheek pads
1. Take hold of the sides of the
acoustic collar and pull it out of its
fi tting.
2. Release the high-comfort chin
pads by pulling the three red pins
out of their plug fi ttings.
3. Take hold of the chinstrap pad and
pull the loop of the neckband out
from around the chinstrap.
71