Husqvarna TC 250 2012 Manual Del Usario página 62

AIR FILTER CHECK
Turn rear pin (1) counterclockwise, remove the saddle from the
front afstening screw.
Remove screw (3) and the filter (4). Separate filter (5) from
frame (6).
1
4
3
EN - 20 SPECIFICATIONS - OPERATION - MAINTENANCE
AIR FILTER AND CLEANING
Wash the filter with a specific detergent then dry it fully (wash
filter with gasoline only in case of necessity).
Plunge the filter in special oil for filters, then wring it to drain
superfluous oil.
CAUTION*: Do not use gasoline or a low flash-
point solvent to clean the element. A fire or
explosion could result.
CAUTION*: Clean the element in a well ven-
tilated area, and do not allow sparks or
flames anywhere near the working area.
5
ASSEMBLY
To ensure tight fit, slightly (C) grease filter edge on side facing
filter housing.
While re-inserting the filter into its housing, make surs that
piece (A) is turned upwards and edge (B) is on the left lower
side of the filter case. Reassemble the parts previously removed
(battery: connect the positive cable first).
CAUTION*: If the element assembly is not
installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of the
piston rings and cylinder.
UPPER SIDE
LATO SUPERIORE
C
6
A
B
LATO SINISTRO
LEFT SIDE