Cebora KINGSTAR 400TS Manual De Servicio página 72

CEBORA S.p.A.
□ Turn knob I to set the current based on the type of welding
required.
□ Bring the torch up to the workpiece to weld and press the torch
start button, contact strike.
♦ Start welding. Use the knob and/or controls on the torch to obtain
current voltage levels best suited to the welding required.
♦ During welding, output current and voltage are shown both on
LCD display H and display on wire feed unit A.
♦ In the cooling unit, pump (26) and fans (2) come on or remain in
operation for a certain amount of time.
□ Release the torch START button.
♦ The arc turns off in the set OFF phase.
♦ The gas outflow continues for the post-gas time set.
♦ In the cooling unit, pump (26) and fans (2) stop after a certain
amount of time when the start button is released.
NORMAL OPERATION
3301045
NO
Correct?
YES
NO
Correct?
YE
NO
Correct?
YE
72
(3.5.4, 3.5.5,
3.5.6, 3.5.9)
(3.5.3, 3.5.8,
3.5.10, 3.5.13)
(3.5.5, 3.5.15)
17/09/2019