Milnor MilTouch-EX 48040H7K Guía Del Operario página 33

Configure Decision Z
2.1.22.
not used
Water Levels
2.1.23.
Set a value for each water level. Water Level 1 must be the lowest level. Water Level 3 must be
higher than Level 1 and Level 2.
Wet-Down
2.1.24.
Set the wet-down level for this machine.
Bath Level Offset
2.1.25.
Set a digital counts value here so the displayed bath level on the Run screen is the same as the
actual bath level in the machine.
Chemical Valves
2.1.26.
Set the number of chemical valves controlled by this machine.
Drain Washout
2.1.27.
Set the number of seconds for the drain washout time.
Name
2.1.28.
Set a machine name to describe the machine on printed reports.
Simulator
2.1.29.
Set this value to YES if this software is running on a personal computer. Set this value to NO if
this is a washer-extractor.
Counts Per 100
2.1.30.
Set the number of flowmeter counts accumulated when 100 units of water flow through the
flowmeter. This value is calculated and entered by the controller when the flow meter is
calibrated according to
Offset Valve Time
2.1.31.
Set the number of tenths of a second before the desired number of counts is accumulated for
the controller to command the water valves to close. This reduces overshoot.
Jog Speed
2.1.32.
Set the basket speed in RPMs when the operator is manually jogging the basket.
Tank Temperature
2.1.33.
Set the temperature for the overhead tank.
Programmable Outputs
2.1.34.
Set the number of programmable outputs available.
Chapter 2. How to Configure and Program the Control
Section 2.3. "How to Calibrate the Flow
29
Meter".
PELLERIN MILNOR CORPORATION