Milnor MilTouch-EX 48040H7K Guía Del Operario página 52

Chapter 3. Troubleshooting
Can't Find Wash Position (24)
3.1.2.6.
position input was not made within the required time limit.
Messages that Can Occur on Automatic Load/Discharge
3.1.3.
MilTouch-EX
Brake Pads Worn (16)
3.1.3.1.
Replace the pads.
Loading Aborted (19)
3.1.3.2.
loading elbow. An error occurred that caused the loading system to stop.
Discharge Aborted (20)
3.1.3.3.
loading elbow. An error occurred that caused the discharge system to stop.
Invalid Formula (21)
3.1.3.4.
Mildata computer.
Load Eye Blocked (22)
3.1.3.5.
loading elbow.
Up Lock Not Made (23)
3.1.3.6.
loading elbow. The controller can not be sure that the elbow is up and locked in a safe position.
Invalid Work Order (24)
3.1.3.7.
Mildata computer.
Invalid Goods Code (25)
3.1.3.8.
Mildata computer.
Invalid Customer Code (26)
3.1.3.9.
the Mildata computer.
Invalid Employee Code (27)
3.1.3.10.
the Mildata computer.
Can't Find Data (28)
3.1.3.11.
not found on the Mildata computer.
Chute Door Not Closed (29)
3.1.3.12.
door is completely closed.
Bifold Door Not Closed (30)
3.1.3.13.
at the top of the load chute is completely closed.
Bifold Door No Open (31)
3.1.3.14.
the top of the load chute is completely open for loading.
PELLERIN MILNOR CORPORATION
—This error appears only on tilting machines. The wash
™
Models Only
—The brake pads used to slow the cylinder after an extract are worn.
—This error appears only on machines equipped with an automatic
—This error appears only on machines equipped with an automatic
—The user entered a value for this field that does not exist in the
—This error appears only on machines equipped with an automatic
—This error appears only on machines equipped with an automatic
—The user entered a value for this field that does not exist in the
—The user entered a value for this field that does not exist in the
—The user entered a value for this field that does not exist in
—The user entered a value for this field that does not exist in
—Mildata machines only. The formula requested by the machine was
—The machine controller cannot confirm that the load chute
—The machine controller cannot confirm that the bifold door
—The machine controller cannot confirm that the bifold door at
48