Milnor MilTouch-EX 48040H7K Guía Del Operario página 35

Soak Wash—a bath step in which the cylinder does not turn
Staged Extract—an extract step used for maximum removal of moisture
1. The cylinder speed increases from drain speed to the extract speed for 150 seconds.
• If the cylinder increases to the set speed in less than 150 seconds, the controller holds the
speed until the 150 seconds completes.
• If the cylinder does not increase to the set speed, acceleration continues until the 150
seconds completes.
2. After the 150 seconds completes, the step timer stops.
3. The cylinder speed decreases to a stop.
4. The cylinder turns clockwise for 8 seconds, coasts for 3 seconds, then turns counter-
clockwise for 8 seconds.
5. The cylinder accelerates to drain speed for 8 seconds.
6. The step timer runs while the basket accelerates to the programmed speed.
7. The step ends when the step timer reaches 0.
Standard Extract—an extract step which accelerates to cylinder to a programmed speed and
maintains that speed for the programmed time
Time
2.2.2.
Program the hours, minutes, and seconds that the step timer will run before it declares that this
step is complete.
Some types start the step timer after requirements are met, such as water level. The time required
Tip:
to meet these requirements will affect the total time of the step and the formula.
Temperature
2.2.3.
Set the temperature desired for a bath step. Units are Fahrenheit or Celsius degrees, as configured.
The valid range is 50 to 205 degrees Fahrenheit (10 to 96 degrees Celsius).
Hot Water
2.2.4.
OFF—Do not open the hot water inlet valve while the machine is filling.
ON—Use hot water while the machine is filling.
Raise Fill Temperature—The hot water valve opens only to increase the bath temperature to the
desired temperature while the machine is filling.
Cold Water
2.2.5.
OFF—Do not open the cold water inlet valve while the machine is filling.
ON—Use cold water while the machine is filling.
Lower Fill Temperature—The cold water valve opens only to decrease the bath temperature to
the desired temperature while the machine is filling.
3rd Water
2.2.6.
OFF—Do not open the 3rd water inlet valve while the machine is filling.
ON—Use 3rd water while the machine is filling.
Chapter 2. How to Configure and Program the Control
31
PELLERIN MILNOR CORPORATION