How To Use The Bobbin Thread Counter - JUKI CP-180 Manual De Instrucciones

10. HOW TO USE THE BOBBIN THREAD COUNTER

The machine detects the number of stitches. The preset value on the bobbin thread counter is subtracted in
accordance with the number of stitches detected. (Subtraction is made according to the setting of function
setting No. 7, bobbin thread count down unit.) When the value on the counter becomes a minus value as " 1 →
0 → -1 ", the buzzer peeps three times to warn the operator that the time to change the bobbin thread has come.
< Initial value on the bobbin thread counter for reference >
The table below gives the initial setting values for
reference when the bobbin is wound with thread
to the extent that the pinhole in the outside of the
bobbin case is reached as shown in the fi gure given
above.
Length of thread wound
Thread used
round the bobbin
Polyester spun
thread #50
Cotton thread
#50
※ Actually, the bobbin thread counter is affected
by the material thickness and the sewing speed.
So, adjust the initial value of the bobbin thread
counter in accordance with the operating conditions.
2
1
Value on bobbin
thread counter
1200 (stitch
36m
length : 3 mm)
1000 (stitch
31m
length : 3 mm)
Thread tension rate 100 %
1) Press bobbin thread counter reset switch 1
to return the value indicated on bobbin thread
counter 2 to the initial value (it has been facto-
ry-set to "0" at the time of delivery).
The bobbin thread counter cannot be reset
during sewing. In this case, make the
thread trimmer actuate once.
3
2) Specify an initial value using bobbin thread
amount setting switch 3 .
When keeping pressing the switch, the change-
over speed is increased.
3) Once the initial value is specifi ed properly, start
the sewing machine.
4) When a minus value is shown on the counter and the
buzzer peeps three times, replace the bobbin thread.
5) After the bobbin thread has been properly re-
placed, press bobbin thread counter reset switch
1 to return the value on the bobbin thread coun-
ter to the initial value. Now, re-start the sewing
machine.
6) If the remaining amount of bobbin thread is ex-
cessive or the bobbin thread runs out before the
bobbin thread counter indicates a minus value,
adjust the initial value appropriately using the "+"
or "-" switch of bobbin thread adjustment switch
3 .
If the remaining amount of bobbin thread is excessive
... Increase the initial value using the "+" switch.
If the remaining amount of bobbin thread is insuffi cient
... Decrease the initial value using the "-" switch.
1. Uneven performance may occur in
accordance with the winding way of
thread or the thickness of materials and
it is necessary to set the thread trimming
amount with some surplus.
2. If the bobbin thread counter is used
in combination with the bobbin thread
remaining amount detecting device, the
bobbin thread counter indicates the number
of detections of the bobbin thread remaining
amount detecting device.
So, be sure to use the device after carefully
reading the Instruction Manual for the
bobbin thread remaining amount detecting
device.
- 12 -