One-Touch Setting; Production Support Function - JUKI CP-180 Manual De Instrucciones

Ocultar thumbs Ver también para CP-180:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 92
校正用

8. ONE-TOUCH SETTING

A part of function setting items can be easily changed in the normal sewing state.
WARNING :
For the setting of functions other than those covered in this part, refer to "Instruction manual for the
SC-920".
* Wiper function (
: Wiper does not operate after thread trimming
: Wiper operates after thread trimming

9. PRODUCTION SUPPORT FUNCTION

The production support function consists of two different functions (five different modes) such as the
production volume management function, operation measuring function. Each of them has its own production
support effect. Select the appropriate function (mode) as required.
< Production volume management function >
• Target No. of pcs. display mode [F100]
• Target/actual No. of pcs difference display mode [F200]
The target number of pieces, actual number of pieces and the difference between the target and actual
number of pieces along with the operation time are displayed to notify the operators of a delay and advance
in real time. Sewing machine operators are allowed to engage sewing while constantly checking his/her
work pace. This helps raise target awareness, thereby increasing productivity. In addition, a delay in work
can be found at an early stage to enable early detection of problems and early implementation of corrective
measures.
< Operation measuring function >
• Sewing machine availability rate display mode [F300]
• Pitch time display mode [F400]
• Average number of revolutions display mode [F500]
Sewing machine availability status is automatically measured and displayed on the control panel. The data
obtained can be used as basic data to perform process analyses, line arrangement and equipment effi ciency
checkup.
2
1
)
< One-touch setting procedure >
1) Keep switch 1 held pressed one second to en-
ter the function setting mode.
2) The set value can be changed by using switch 2 .
3) To return to the normal sewing state, press
1
switch
.
The setting is confirmed by pressing
switch 1 .
- 9 -

Publicidad

Tabla de contenido
loading

Tabla de contenido