Installing The Control Panel; Connecting The Cord - JUKI CP-180 Manual De Instrucciones

校正用
WARNING :
This Instruction Manual is for the control panel, CP-180.
Read "Safety Instructions" of the Instruction Manual for the control box carefully beforehand and
understand them before using CP-180.
In addition, be careful not to splash water or oil on it, or shock such as dropping and the like since
this product is a precision instrument.

1. INSTALLING THE CONTROL PANEL

WARNING :
To prevent personal injury caused by abrupt start of the sewing machine, carry out the work after
turning OFF the power switch and ascertaining that the motor has completely stopped.
1) Remove side plate setscrews 1 from the side plate.
2) Install control panel 2 on the machine head using screws 5 , fl at washers 3 and rubber seat 4 sup-
plied with the control panel as the accessories.
1. DDL-9000B (Not provided with AK) is given as an example of installing procedure.
2. Screw to install the panel changes according to the machine head used. Refer to Table 1 and
confi rm the kind of screw.
< The relation between the respective machine heads and the positions of installing hole of the bracket are as described in the table. >
1 2

2. CONNECTING THE CORD

A
1
3 4 5
6
1
2
4
Table 1
Installing hole
1 - 5
DDL-9000A
(Provided with AK)
1 - 5
DDL-9000B
(Not provided with AK)
2 - 5
LH-3500A
1) Pass cord 1 of the control panel through hole A
in the machine table route it to the underside of
the table.
2) As for the connection of the connector, refer to
the Instruction Manual for the control box.
- 1 -
3
5
Screw
Screw supplied with panel
M5 X 12
as accessories
Side plate setscrew
M5 X 14
Screw supplied with panel
as accessories
M5 X 12
M5 X 14 Side plate setscrew