Measuring Ac Current - KPS PA50 MINI Manual De Funcionamiento

KPS-PA50 MINI • Digital clamp meter
the specified value in order to protect the internal circuit from damage.
• Turn the rotary selector to the required function and range to be measured.
Under the manual mode, choose the highest range when the value scale to
be measured is unknown.
• Connect the common test lead first and then the charged test leads when
making connection. Take away the charged test lead first when disconnect-
ing.

4.9 Measuring AC current

Beware of Electrocution. Ensure that the test leads are disconnected
from the meter before making current clamp measurements.
• 1)Set the rotary selector to the A ~ range position.
• 2) Auto range mode or manual range mode can be selected by pressing the
"RAN" button.
• 3) Press the trigger to open jaw. Fully enclose only one conductor.
• 4) Take the reading on the LCD.
NOTE:
1) Do not put more than one cable into the jaw during test, otherwise incorrect
test value might be obtained.
2) For optimum results, center the conductor in the jaw.
3) At the manual range mode, when only 'OL' is shown on the LCD, it means
the measurement has exceeded the range. A higher range should be selected.
4) Under the manual range mode, when the scale of the value to be measured
is unknown beforehand, set the range to the highest.
5) " " means the maximum input current is 600A rms AC.
WARNING
41